3D Printer Training: Basics


August 8


06:00 pm - 08:00 pm

Click to Register: Click to Register

North Forge Fabrication Lab

Website: Organizer's Website

North Forge Fabrication Lab

125 Adelaide St. 3rd Floor

Winnipeg, MB, CA

We will be learning the 3D printing basics, focusing on the Prusa i3 MK2 and its slicing software: Slic3r Prusa Edition. Similarities and differences will be pointed out on the Ultimaker 2+ Extended, Sindoh 3DWox and uPrint 3D Printers, as well as basic operation and their software. We will go over adding support materials, basic printer maintenance, hardware operation, and software operation.


Layer height



Rafts and Adhesion


Filament usage

Your trainer is: Richard Venzon. You can contact Richard through the Meetup Messages system or Slack. If you are having trouble contacting Richard, please comment below.

Payment online is required no later than 24 hours before the start of the session ($52.50 includes GST). If you cannot pay online contact us to make alternate arrangements prior to the training session. If you are unable to attend the training and do not attempt to contact the trainer at least 24 hours prior to the start of the training, you will be liable for the full cost of the training. Exceptions will be made under reasonable circumstances.

More Stories
The Monday-Friday Idiot(s) Album Release Party